Screen-Rant-vividplease: DIY: How To Make A Book Clock!

Ok ok, I didn't kill a book. I simply gave it a new purpose in life!

I adore books, big ones, small ones, ones with amazing covers... but sometimes you run out of space and can't keep them, especially if you don't plan on reading them again. But what happens when you found a book you can't bear to part with because of its cover? Well, I'm glad you asked...

Up-cycle it into a clock!

Sometimes the simplest things in life bring the greatest pleasure. Time flies when reading a good book, so why not turn that enjoyable time into a fabulous clock? All you need to make your own is an old and enjoyed book, a brush and glue, a drill, scalpel and a clock mechanism. You can get these off ebay really easily for only couple of quid too :)

To start, we'll need to glue the book closed so it doesn't flap about. We did the same thing when we showed you how to make the Hollow Stash Book and it works a treat. Begin by cling filming the front and back cover of the book so it doesn't get glued.

Then use your mod podge or pva glue to stick all the pages together. Once you've given it all a good coating, place it under some heavy books so it dries flat. The glue will go clear when it's dry, so don't worry if it's a little messy.

When it's ready you'll need to check the depth of your book with the clock part. This little novel is perfect as I don't need to cut a well into the back so it fits. Should you find your book is too thick, measure the size of the backing and cut into the back of the book the same way we did for the stash book. This will make the backing sit more flush and let the front fit through properly.

To put the main clock post through the book you'll need to drill it. Start by clearly marking the middle of the book (where you want the center of the clock hands to sit) on the first page. We'll be drilling the pages first and finish the cover later, so just ignore it for now.

The best way to drill a hole is to start with a small drill part and work your way up. As you'll be pressing down through the book to make a hole, you'll need to do it on something you don't mind getting a hole in it incase you go too far! Some old magazines will do the trick should you not have a proper workspace. Make sure to stop frequently to check how deep you've gone.

Work your way up the drill parts till you've made a hole with a big enough diameter to fit the clock post through. This part takes the longest, but it's worth taking your time over - you don't want to make it too large or the clock mechanism wont fit.

Next we need to put a hole in the front and back cover. Using the hole we just drilled in the book, use a pencil to trace onto the cover where your hole needs to be. Then use your scalpel to mark an X into the front and back cover.